How To Measure Driveshaft Length. With the old driveshaft removed, measure the distance between the end of the transmission tailshaft housing and the leading edge of the rearend housing yoke. Determined by driveshaft length and peak rpm.
Dennys driveshaft has the best measuring diagrams in the business. It easy to get a driveshaft that fits perfectly. Transmission output types spline seal and rubber boot extension.
Table of Contents
This Will Affect The Distance Between The Back Of The Transmission And The Pinion Flange On The Rear Axle.
Measure transmission tail shaft length. Take the driveshaft off, remove the slip stub, and measure the length of spline. Measure small parts with a straight ruler (preferably metal) and / or a caliper (preferably digital) for greater accuracy.
Pick The Diagram That Looks Like Your Application.print It Out And Fill In All The Answers And Please Be Sure To Measure Exactly As It Shows.
Diagram b & diagramc are used most often for street rods, race cars and 4×4 trucks. How to measure driveshaft length for your t56 magnum swaps one of the most common questions i get is how to measure for your driveshaft. This takes some time, and we may need to contact you for additional information or specifics before we can finalize it for you.
The Way I Prefer You To Do This Is To Take The End Of The Tap, And Put It On The Face Of Your Rear Differential Flange, Then Pull The Tape Up To The Transmission, And Take A Picture So I Can Verify The.
Now push your transmission yoke all the way into the transmission. Now push your transmission yoke all the way into the transmission. Determining length when you don't have a driveshaft to measure:
The Key For Figuring Out How Much Spline Engagement You Currently Have Is To Measure.
With the old driveshaft removed, measure the distance between the end of the transmission tailshaft housing and the leading edge of the rearend housing yoke. The right way to do it is to measure. To obtain accurate measurements for new driveline lengths, follow these guidelines:
When Measuring Driveshaft Length, The Vehicle’s Weight Must Rest On The Rear Suspension.
Transmission output types spline seal and rubber boot extension. You will need a tape measure and a good 6 ruler. Insert the correct slip yoke into the rear of the transmission until it bottoms, then back it out 3/4 of an inch.